Furuno NAVpilot-700, Руководство по установке

Страница: 56 / 100

3. INITIAL SETTINGS
3-20
3.8 Sensor Setup
Before doing this procedure, turn on all CAN bus equipment connected to the CAN bus
network of the NAVpilot.
SENSOR SYNC
1. The cursor is selecting [SENSOR SYNC]; push the knob.
2. Select [ON] or [OFF] to push the knob.
When [SENSOR SYNC] is set to [ON], the sensors connected to NavNet 3 or NavNet
TZtouch devices are available for NAVpilot.
HEADING SENSOR
1. Turn on all sensors then push the knob.
2. The cursor is selecting [HEADING SENSOR]; push the knob.
When [AUTO DETECT] is selected to [YES], all the heading sensors connected to the
NAVpilot are shown. In case of multiple heading sensors, the sensors are ordered by
FURUNO CAN bus heading sensor, other CAN bus heading sensor, NMEA 0183
heading sensor. If desired you can change the order; select number, push the knob,
rotate the knob to select a sensor then push the knob. [AUTO DETECT] automatically
re-orders sensors in the above-mentioned order. Select [YES] at [AUTO DETECT] to
re-order.
3. Set up speed, position, wind, depth and temp sensors similarly.
SENSOR SELECTION
SENSOR SYNC: ON
HEADING SENSOR
SPEED (STW)
SPEED (SOG)
POSITION SENSOR
WIND SENSOR
DEPTH SENSOR
TEMP SENSOR
HEADING SENSOR
AUTO DETECT : NO
1ST:
PG-700 : 0019E4
2ND: - - - - - - - - - - - - - -
3RD: - - - - - - - - - - - - - -