Furuno NAVpilot-700, Руководство по установке

Страница: 57 / 100

3. INITIAL SETTINGS
3-21
3.9 Universal Port Setup
The [UNIVERSAL PORT] menu sets up the GENERAL IN and GENERAL OUT ports.
GENERAL IN : A switch box is connected to this port to control the NAVpilot from a remote
location.
GENERAL OUT : A buzzer sounds or a lamp lights at a remote location when the specified
function is done on the NAVpilot.
If you have equipment connected to only the GENERAL OUT port, go to step 5.
1. The cursor is selecting the setting for [IN PORT1]; push the knob.
2. Rotate the knob to select the command or function for [IN PORT1]. This is the com-
mand or function assigned to the switch box connected to this port.
[DISABLE]: The port is disabled.
[AP ENABLE]: Select ON to get full control of the boat with the NAVpilot. In the OFF
setting only the STBY mode is available.
[GO STBY]: The switch, when operated, puts the NAVpilot in the STBY mode.
[GO AUTO]: The switch, when operated, puts the NAVpilot in the AUTO mode.
[PORT ARROW KEY]: The switch, when operated, controls the
W key on the NAVpi-
lot.
[STBD ARROW KEY]: The switch, when operated, controls the
X key on the NAVpi-
lot.
[FUNCTION KEY]: Assign function of equipment connected to NAVpilot.
3. If you selected [FUNCTION KEY], do the following to select a function. If not go to
step 4.
1) Rotate the knob to select [FUNC KEY] then push the knob.
Note: For Fantum Feedback
TM
, when the [INPORT 1] or [INPORT 2] is selected to
[FUNC KEY], only the [TURN 180
°
] is selective.
UNIVERSAL PORT
IN PORT1: DISABLE
IN PORT2: DISABLE
OUT PORT1: DISABLE
OUT PORT2: DISABLE
DISABLE
AP ENABLE
GO STBY
GO AUTO
PORT ARROW KEY
STBD ARROW KEY
FUNCTION KEY*
* This feature is not available when
boat type is selected as sailboat.
TURN OF 180
°
CIRCLE
ORBIT
SPIRAL
SQUARE
FIG 8
ZIGZAG