Furuno NAVpilot-500, Руководство по установке

Страница: 20 / 67

2. WIRING
2-2
2.2 Processor Unit
All cables run into the processor unit from the cable entrance and are connected to the
terminal board inside.
2.2.1 How to fix cables to the clamp
Cables are not location-specific so you may fix them on the cable clamp in any order.
1. Unfasten five pan head screws to remove the cover.
2. Unscrew five pan head screws to dismount the clamp stopper.
Processor unit, clamp stopper
3. Twist cable cores, and then insert them into the cable block as appropriate.
4. For NMEA cable, wind vinyl tape (local supply) around cable cores.
5. Fasten three cable ties to attach a cable to the appropriate leg of the processor unit as
below.
Clamp leg
Cable
Cable ties
Braided shield
(If your cable doesn't
have braided shield,
wind the copper tape
around alminum foil.)
Drain wire
Vinyl tape
Cable block
How to fix the cable to clamp leg