Furuno FSV-85, Руководство по установке

Страница: 29 / 83

2-1
2. WIRING
2.1 How to Use the Crimping Tool, Pin Extractor
A special crimping tool is necessary for connection of wires to the contact pins of the
38P connector. The pin extractor removes the contact pin from the connector body.
This paragraph describes how to crimp and extract the contact pin.
2.1.1 How to use the crimping tool
1. Remove the vinyl sheath by 3 to 4 mm to expose the core.
2. Hold the crimping tool horizontally and insert
the contact pin with its slit facing downward
into the crimp hole on the crimping tool.
3. Insert the wire onto the contact pin and
squeeze the handle until the ratchet releases.
(The wire should be placed deep enough into
the contact pin so that its end comes in con-
tact with the stopper plate of the crimping
tool.)
4. With crimping completed, pull the wire while
holding the contact pin to make sure that the wire is held firmly by the contact pin.
2.1.2 How to use the pin extractor
If a contact pin is inserted into an incorrect
hole on the connector body, remove it with the
pin extractor.
1. Push the pin extractor into the pin hole
from the side opposite to the pin inserting
side.
2. Push in the head of the pin extractor. The
retaining spring comes free and the con-
tact pin can be removed.
Crimping Tool
06-1001-016
Contact Pin
60-8017-0313-00339F
(000-159-417-10)
Pin Extractor
06-1877-04
(000-519-595)