Furuno FCV-627, Руководство оператора

Страница: 49 / 65

4. INSTALLATION
41
19°-22° transom angle (small alumi-
num and fiberglass boats)
: Position the
shim with the tapered end up.
Sensor position and transom angle
3. If the bracket has been temporarily fas-
tened to the transom, remove it. Apply a
marine sealant to the threads of the three
#10 x 1-1/4" self tapping screws to pre-
vent water seeping into the transom.
Screw the bracket to the hull. Do not tight-
en the screws completely at this time.
4. Repeat step 1 to ensure that the angle of
the sensor is correct.
Note: Do not position the sensor farther
into the water than necessary to avoid in-
creasing drag, spray, and water noise
and reducing boat speed.
5. Using the vertical adjustment space on
the bracket slots, slide the sensor up or
down to provide a projection of 3 mm (1/
8"). Tighten the screws.
Vertical adjustment and cable routing
Attaching the sensor to the bracket
1. If the retaining cover near the top of the
bracket is closed, open it by depressing
the latch and rotating the cover down-
ward.
Attaching the sensor to the bracket
2. Insert the sensor's pivot arms into the
slots near the top of the bracket.
3. Maintain pressure until the pivot arms
click into place.
4. Rotate the sensor downward until the bot-
tom snaps into the bracket.
5. Close the retaining cover to prevent the
accidental release of the sensor when the
boat is underway.
Cable routing
Route the sensor cable over the transom,
through a drain hole, or thorough a new hole
drilled in the transom above the waterline.
Never cut the cable or remote the connector;
this will void the warranty. Always wear safety
goggles and a dust mask.
1. If a hole must be drilled, choose a location
well above the waterline. Check for ob-
structions such as trim tabs, pumps, or
wiring inside the hull. Mark the location
with a pencil. Drill a hole through the tran-
som using a 19 mm or 3/4" bit (to accom-
modate the connector).
2. Route the cable over or through the tran-
som.
2
°
- 10
°
transom
angle
11
°
transom angle
NO SHIM
19
°
-22
°
transom
angle
shim with
taper down shim with
taper up
YES YES
YES
parallel parallel parallel
12
°
-18
°
transom angle
NO SHIM
NO NO
YES
angle
reversed
slight
angle
angle too
steep
Cable cover
Cable
clamp
50 mm (2")
Hull projection 3 mm (1/8")
Step 1
Step 2
Step 3
Step 4
Latch
Pivot
arm (2)
Slot (2)
Retaining
cover