7 Crank handle
installation
The crank handle will now be installed
on the right hand leg. First, assemble the
parts needed as shown in the picture.
Insert in to the opening in the top of the
right hand side leg, and tighten the small
black screws in the handle connector
when position is set. NOTE: Before
tightening screw, make sure that the
handle is out far enough so that it can turn
when folded out from under the desk top.
Use 4 x Part F screw to drill the handle mount in to
place on the under side of desk top
Parts used
Handle
Handle Axle,
Handle Connector,
Handle Support
Fx4
Ex2
Part F
Axle Handle
Handle Connector
Handle Support
Handle
Part N: 2 lengths available depending on customer’s requirement.
Only 1 needs to be used.
