Funkwerk elmeg t444, Руководство по эксплуатации, Страница: 23 / 84

Please note that you must first allocate a multiple subscriber number (MSN) or direct dial-in number to this service number during PC con-
figuration.
Room monitoring is protected by a 6-digit PIN 2 and can be activated by entering this PIN 2.
In the initial state, this PIN 2 is set to
000000
. To ensure adequate security you must change this 6-digit PIN 2
and enable remote access to the PABX if you wish to use this feature.
You are at an external telephone.
Lift up the handset of the phone from which you wish to conduct room monitoring and dial the MSN or direct dial-in number to which the
service number for the PABX is assigned.
If remote access has been enabled and is possible at this time you will hear the special dial tone of your PABX.
Set your phone to frequency (DTMF) dialing, or use a DTMF manual transmitter.
t q t q
Enter PIN 2 Ack.
signal
Dial the number of the telephone
to be used for room monitoring
Ack.
signal
Room monitoring is activated
To end room monitoring, hang up the handset of the external telephone.
Tracing (Malicious call identification)
You must apply for this feature to your service provider. You will then be informed of further procedures there. If you dial the appropriate
code during a call, or after the caller has ended a call (you will hear the busy signal from the exchange) the caller's number is saved at the ex-
change. ISDN telephones can also use dedicated functions for this feature.
Attention: Only hang up the handset after you have entered the code for tracing the caller and hear the positive ac-
knowledgement signal.
g *51 q a
Ongoing call, or caller
hangs up
Ack.
signal
Replace
handset
Allocating Project Numbers
Project numbers allow you for example to invoice telephone calls for specific customers. If you have initiated calls yourself you can save the
data for call duration and costs for this customer under the project number. If you are called by a customer, you can store the call data for this
particular customer.
A project is activated by entering a code and a project number consisting of up to 6 digits.
If you have exported call data records using the charge manager software on the CD, you can, for example, sort, filter or compile these data
records according to project numbers.
Assigning a project number for a call you initiate
b *50 t # q t
Lift up
handset
Enter project number
(max. 6 - place)
Ack.
signal
Dial call number
Calling several telephones (team call)
19