Functional Devices, Inc.
101 Commerce Drive
Sharpsville, IN 46068
Toll Free:
(800) 888-5538
Office:
(765) 883-5538
Fax:
(765) 883-7505
Email:
Website:
www.functionaldevices.com
Occupancy / Vacancy Sensor Only Learn Procedure
1. Charge the Occupancy / Vacancy Sensor per instructions.
2. Apply power to FDLR product.
3. Press and hold LRN button on FDLR product until LED starts flashing slowly (approximately 1/2 second).
4. Trigger a Teach telegram from the Occupancy / Vacancy Sensor by pressing the Menu button once.
5. LED on FDLR product will stay ON for 4 seconds acknowledging telegram reception.
6. Repeat steps 3-5 for additional Occupancy / Vacancy Sensors.
Optional Modes
page 4
• Relay state after power-up can be set to ON, OFF or LAST STATE
• Relay state after power-up is LAST STATE by default.
Setting Relay State to OFF at Power-up:
1. While device is not powered, press and hold the LRN button.
2. Power-up the device.
3. Wait approximately 3 seconds until the LED blinks 3 times.
4. Release the LRN button.
Relay will always be OFF at power-up.
Setting Relay State to ON at Power-up:
1. While device is not powered, press and hold the CLR button.
2. Power-up the device.
3. Wait approximately 3 seconds until the LED blinks 2 times.
4. Release the CLR button.
Relay will always be ON at power-up.
Setting Relay State to LAST STATE at Power-up: (Default Mode) **
1. While device is not powered, press and hold the LRN and CLR buttons.
2. Power-up the device.
3. Wait approximately 3 seconds until the LED blinks 1 time.
4. Release the LRN and CLR buttons.
Relay will return to LAST STATE at power-up.
Relay State
• Activating Repeater Mode allows FDLR product to repeat signals from other EnOcean devices within range. The FDLR product “hears”
the signal and echoes it but will not respond to it unless it has been linked to the transmitting device.
• FDLR product will allow a signal to be repeated up to two times.
Enabling Repeater Mode
1. Apply power to FDLR product.
2. Press and hold LRN button on FDLR product until LED starts
flashing slowly (approximately 1/2 second).
3. Press and hold the CLR button for 3 seconds until LED flashes
twice
indicating Repeater Mode is enabled.
Disabling Repeater Mode
1. Apply power to FDLR product.
2. Press and hold LRN button on FDLR product until LED
starts flashing slowly (approximately 1/2 second).
3. Press and hold the CLR button for 3 seconds until LED
flashes
three
times indicating Repeater Mode is disabled.
Repeater Mode
B. Auto On:
FDLR Product and an Occupancy / Vacancy Sensor (FDLTVW or FDLTVC)
• Relay activates when occupancy is detected and deactivates 30 minutes after last detection of occupancy.
• It may take up to 2 minutes for the FDLR product to respond to the Occupancy / Vacancy Sensor immediately following Link.
• Optional mode: Repeater (see page 4)
393278
