PIN LOCATION
PIN is stamp marked on an aluminum plate that is riveted on the front frame. ( see picture 4).
PIN means the Product Identify Number which is unique for each unit.
Inflating the Tires
NOTE:
The 6” rear tires are inflated when shipped, but they invariably lose some pressure
between the point of manufacturing and your purchase. Always inflate the tires to the correct
PSI before first time use.
Please read the specification sheet to get the information of tire pressure.
Using a bicycle-style tire pump to inflate the tire to the PSI indicated on the sidewall of the tire.
Note:
The pressurized air supplies found at gasoline stations are designed to inflate
high-volume automobile tires. If you decide to use such an air supply to inflate your tires, first
make sure the pressure gauge is working, then use very
short bursts to inflate to the correct PSI. If you inadvertently over-inflate the tire, release the
excess pressure immediately.
Important information of use guider for tire
Note
: Tire is the only contact between the vehicle to the road, the safety of various driving
activity depends on the small area of tire where contact with the road. Therefore, it is very
important to keep the tire in good condition any time and use the correct size and standard tire
to replace the old ones.
Guide:
Tire assembly and disassembly
It is strongly recommended that the tire assembly and disassembly should be done by an
authorized technician with necessary skills.
Tire inflating pressure
It is very important to keep the tire in proper pressure and check the tire pressure before use.
The inflating should be done while the tire is cold.
