●
CHECKS AFTER CLEANING
After cleaning the motorcycle, it is good practice to:
·
Take off the flywheel cover and remove any dirt and water.
·
Apply the lubricant above articulation points
A
and
B
on
the rear and front swing arm .
·
Carefully clean and dry the chain-gear-position
assembly and then apply grease thoroughly in order keep
these parts in good condition as long as possible.
·
Dry well any metal parts subject to corrosion, oxidation, etc.
●
ADJUSTMENTS
The front and rear brakes is a mechanically operated disc
brake, which require periodic adjustment. As shown in the
figure, there should be 5-6 mm play, to adjust the play,
follow these steps:
-Check the play in driving position.
-If the clearance is excessive, use adjuster A on the
brake lever to obtain the desired position.
-Tighten locknut
B
.
Note:
The front and rear brake calipers are equipped
with an adjuster
C
that allows the braking action to be
adjusted by moving the brake lever towards or away
from the disc.
Note:
To adjust the tension of the brakes cables, loosen
self-locking nut
C
, retension the cable and then tighten
fastener
C
again.
●
●
●
●
ADJUSTMENT OF IDLING SPEED
In order to perform this operation correctly, we advise you
to do it when the engine is hot, connecting an electri
revolution counter to the spark plug wire. Then use a
screwdriver on register screw
A
to calibrate the minimum.
