23
2”
6.75”
6.75”
2”
3.
Line up the Side Bracket from 1.a above, with the screw holes on the (larger) Side Bracket 2” from the edge,
and the front-most hole at least 6.75” from the front of your desktop.
4.
Slide the Center Rails into the open Frame End from the Corner Assembly.
5.
Create the final Frame End assembly with the remaining Frame End and Side Bracket.
6.
Slide this new assembly onto the Center Rails from Step 4, and position them as you did with the original
Frame End Assembly in Step 3. The example on the following page shows a desk top that is 27” deep on
either side and 56” wide on either side.
7.
Use the tip of a Philips screwdriver to mark the center point of each hole —this is more accurate and perma-
nent than using a marker or pencil.
8.
Remove all frame components from the desktop - you’ll need these later to assemble your frame. Using the
marks from step 7 drill pilot holes into your desktop. You’re now ready to assemble and attach the frame as
shown in Pages “11-17” during Steps “10-17.”
