8
ASSEMBLY
Removing and Fitting the Chisel
The Full Boar FBT-1100 comes with 2 chisel attachments that require fitting before starting
the demolition hammer.
1.
Pull back the accessory locking sleeve towards the body
of the tool.
2.
Slide the chisel shank out of the accessory holder. Clean
the SDS max accessory shank with a dry cloth after
removal.
3.
To fit a chisel rotate and insert the SDS max accessory
into the accessory holder as far as it will go while holding
the locking sleeve back.
4.
Secure the chisel in place by releasing the accessory
locking sleeve.
Pull on the attachment to check that the chisel is secure.
Note:
The accessories will have a small amount (approx.
10-12mm) of back and forth movement from the
accessory holder, this is normal.
Note:
To avoid damage to the SDS max accessory holder, only use SDS max accessories.
Damage caused to the SDS max accessory holder by using incorrect accessories will
not be covered under warranty.
Fig. 3
Fig. 4
Fig. 5
Fig. 6
WARNING!
Accessories can be hot after use, always wear gloves to prevent
burns or lacerations.
IMPORTANT!
Always lubricate the accessory fitment prior to inserting them into
the demolition hammer. Using your finger, apply grease sparingly to the shaft of
the accessory. Lubricating the accessory will prolong the life of your tool. Non-
lubrication of accessories will void your warranty.
