FULGOR F4SP30x1 Series, Инструкция по использованию и уходу

Страница: 10 / 96

ENGLISH
10
Use & Care Manual
Control panel description
The oven control panel is made with one display and
two knobs.
- Time & Temperature display.
- Time & Temperature knob (Push & Shuttle).
- Mode (oven functions) knob.
The push & shuttle knob is mainly for clock or
temperature setting and automatic time functions
programming. Select the desired item by pushing the
knob.
Electronic control
Programming time functions
At every power-up, the control shows the time of day
/ \]6^^
AM as the initial value. The time
increases every minute. The only possible action is
the “Clock Regulation”, all other oven operations are
inhibited.
In general, turn the Temp/Time selector left or right in
order to edit the values and modify them by steps; hold
the knob on the left or right to fasten the decrease/
increase operations.
Setting the time of day
+ \]6^^ AM/PM
hours format. Hours and minutes are set separately.
In order to set the time of day, mode selector must be
in ZERO position, the -/+ knob acts on the time of day
by default.
| } *
| & *
left/right.
- Push the Temp&Time selector to switch back and
forth between hours and minutes.
| & * }
- After a few seconds the whole time of day value
*6 + +
steady.
Push the knob to toggle between the time of day and
the minute minder and check the set values. The clock
is selected by default while the
symbol appears
when the minute minder is displayed.
Setting the minute minder
When the symbol is displayed, turn the knob left/
right in order to set the timer value.
The standard value is 30 minutes, it’s possible to
modify it in the range between 0 and 240 minutes.
*
can be set also when the oven is off. The time of day
is displayed with priority in any case, the
symbol
shows the minute minder is active.
When the time expires, the
*
buzzer sounds a warning sequence (two short beeps
repeated every 3 seconds) to recall the user attention.
Push the knob to stop it.
The buzzer stops in any case after a time-out.
Buzzer volume
The buzzer volume can be set turning the Time&Temp
knob to the left when the control is in light mode. At any
detents the buzzer sounds a double beep, selecting
the volume out of three available levels. The buzzer
+ + ]]6^^ ~6^^
Temperature Unit Measurement
To select Fahrenheit or Celsius press +/- knob twice,
when the display shows F or C turn +/- knob to
change the unit on measurement, press again +/-
/
TEMP & TIME
MODE