40
U41615-J-Z156-1-76
Operating and Indicator Elements
Preparation for Use/Operation
5
Identification indicator (blue)
Lights up blue when the system has been selected by pressing the
identification button (7). To deactivate, press the button again. The
identification indicator lights up synchronously with the corresponding
indicator on the rear.
The indicator can also be selected via ServerView and its status is also
reported to ServerView.
6
RST
Reset button
Pressing the reset button with a pointed object (e.g. a bent paperclip)
reboots the system.
7
ID
Identification button
Pressing this button lights up synchronously the identification
indicators on the front and on the rear of the server.
8
ON/OFF button
When the system is switched OFF, it can be switched ON by pressing
the ON/OFF button. When the system is operating, pressing the
ON/OFF button will switch OFF the system. More hints may be found
in section
“Other ON/OFF possibilities” on page 45
I
The ON/OFF button does not disconnect the server from the
mains voltage. To completely disconnect it from the mains
voltage, remove the power plug from the socket.
9
NMI
NMI button
Pressing the NMI button with a pointed object (e.g. a bent paperclip)
shuts the operating system down immediately.
I
Please, do not use it! The NMI button may only be used by
service personnel.
10
Power-on indicator (bicolor)
Lights up green when the server is switched ON.
Flashes green when the system is in standby mode.
Lights up amber when the server is in shutdown mode (shut down of
the operating system) and/or is switched OFF.
Table 3: Indicators and operating elements on the front
