C141-E045-02EN
5 - 73
I) The CRC generator polynomial is : G (X) = X16 + X12 + X5 + 1.
Note: Since no bit clock is available, the recommended approach for calculating CRC is
to use a word clock derived from the bus strobe. The combinational logic shall then be
equivalent to shifting sixteen bits serially through the generator polynominal where DD0 is
shifted in first and DD15 is shifted in last.
5.5.6
Series termination required for Ultra DMA
Series termination resistors are required at both the host and the device for operation in any of
the Ultra DMA Modes. The following table describes recommended values for series
termination at the host and the device.
Table 5.11 Recommended series termination for Ultra DMA
Signal
Host Termination
Device
Termination
DIOR-:HDMARDY-:HSTROBE
33 ohm
82 ohm
DIOW-:STOP
33 ohm
82 ohm
CS0-, CS1-
33 ohm
82 ohm
DA0, DA1, DA2
33 ohm
82 ohm
DMACK-
33 ohm
82 ohm
DD15 through DD0
33 ohm
33 ohm
DMARQ
82 ohm
33 ohm
INTRQ
82 ohm
33 ohm
IORDY:DDMARDY-
:DSTROBE
82 ohm
22 ohm
Note: Only those signals requiring termination are listed in this table. If a
signal is not listed, series termination is not required for operation in an Ultra
DMA Mode. For signals also requiring a pull-up or pull-down resistor at the
host see Figure 5.8.
Figure 5.8
Ultra DMA termination with pull-up or pull-down
Содержание MPB3021AT
