50
SECTION 2
6 Connector Box
The connector box is described here.
IMPORTANT NOTE
•
The connector box can be installed/removed regardless of the condition of the PC. If the
FDD unit is connected to the FDD unit connector of the connector box, however, install/
remove the connector box after switching the PC power off.
•
Certain peripheral devices connected to the connector box may operate unstably if the
connector box is installed/removed while the PC power is on. If this happens, switch the PC
power off prior to installing/removing the connector box.
This section describes how to install the connector box.
If any peripheral device is connected to the PC rear side, remove it beforehand.
CAUTION
Injury
•
Be careful not to catch your fingers in the space between the PC and the connector
box when installing it. It may cause an injury.
1
Install the connector box to the PC bottom side.
Fitting the connectors on the PC and the connector box, lower the PC horizontally (1), lightly
press the parts shown below (2), and firmly set the connector box.
IMPORTANT NOTE
•
To install a peripheral device to or remove it from the connector box, be sure to switch the
PC power off and disconnect the AC adapter in advance.
•
Do not carry the PC with the connection box installed. The connectors on the PC and/or the
connector box may be damaged.
Installing the connector box
Connector box
c o n n e c t i o n
connector
1
2
2
Thyme Sec2_50-60
19/10/2000, 20:22
50
