Fujitsu LifeBook N3500, Руководство пользователя

Страница: 74 / 104

68
L i f e B o o k N S e r i e s N o t e b o o k – S e c t i o n S i x
Your LifeBook note-
book will not work on
battery alone.
(continued)
Your installed battery is faulty. Verify the condition of the battery using the Status
Indicator panel and replace or remove any battery
that is shorted.
(See Status Indicator Panel on page 14
for more information)
The battery seems to
discharge too quickly. You are running an application
that uses a great deal of power
due to frequent hard drive or
media player drive access, use of a
modem card or a LAN PC card. Use both the primary battery and/or use a power
adapter for this application when at all possible.
The power savings features may
be disabled. Check the power management and/or setup utility
settings in the Power Options menu and adjust
according to your operating needs.
The brightness is turned all
the way up. Turn down the brightness adjustment. The higher
the brightness the more power your display uses.
The battery is very old. Replace the battery.
The battery has been exposed to
high temperatures. Replace the battery.
The battery is too hot or too cold. Restore the LifeBook to normal operating tempera-
ture. The Battery Charging icon on the indicator
panel will flash when the battery is outside operating
range.
The Mode light is on constantly. Turn off the Mode light by turning system power
off, then pressing the Power/Suspend/Resume
button for four or more seconds.
Shutdown and Startup Problems
The Power/Suspend/
Resume button does not
work. The Power/Suspend/Resume
button is disabled from the
Advanced submenu of the Power
menu of the setup utility. Enable the button from the setup utility.
You did not hold the button in
long enough. Hold the button longer. This may need to be a few
seconds if your application is preventing the CPU
from checking for button pushes.
There may be a conflict with the
application software. Close all applications and try the button again.
The system powers up
and displays power-on
information, but fails to
load the operating
system. The boot sequence settings of the
setup utility are not compatible
with your configuration. Set the operating source by pressing the [ESC] key
while the Fujitsu logo is on screen or use the [F2]
key and enter the setup utility and adjust the source
settings from the Boot menu.
(See BIOS Setup
Utility on page 29 for more information)
You have a secured system
requiring a password to load your
operating system. Make sure you have the right password. Enter the
setup utility and verify the Security settings and
modify them as accordingly.
(See BIOS Setup Utility
on page 29 for more information)
Internal hard drive was not
detected. Use the BIOS setup utility or Primary Master
submenu, located within the Main menu, to try to
auto detect the internal hard drive.
Problem Possible Cause Possible Solutions
N3510.book Page 68 Tuesday, January 18, 2005 11:05 AM