SECTION 2
49
SECTION 2
Your Fujitsu LifeBook comes with 64MB of high speed Synchronous Dynamic RAM (SDRAM) factory
installed. To increase your LifeBook’s memory capacity, you may install an additional memory upgrade
module. The memory upgrade must be a dual-in-line (DIMM) SDRAM module.
6.
Memory Upgrade Module
Installing A Memory Upgrade Module
To install a memory upgrade module follow these steps:
CAUTION
Do not remove any screws from the memory upgrade module compartment, except the ones
specifically shown in the directions for installing and removing the memory upgrade module.
1.
Turn off power to your LifeBook using the power switch,
and remove any power adapter (AC or auto/airline).
2.
Turn your LifeBook face down on a clean work surface.
3.
Using a Phillips head screwdriver, remove the screw
securing the RAM Expansion cover. Remove the cover.
WARNING
You must turn off power before installing the memory
upgrade module.
4.
Align the connector edge of the memory upgrade module,
chip side up, with the connector slot in the compartment.
5.
Insert the memory upgrade module at a 45
°
angle and
press it firmly onto the connector.
6.
Press the memory upgrade module down into the
compartment until it locks underneath the retaining clip.
You will hear a click when it is properly in place.
7.
Replace the cover over the memory tray and reinstall the
screw.
CAUTION
The memory upgrade module can be severely
damaged by electrostatic discharge (ESD). Be sure
you are properly grounded when handling and installing
the module.
Critical Point
The memory upgrade module is not something you
routinely remove from your LifeBook. Once it is
installed, you should leave it in place unless you want
to increase system memory capacity.
I Series_46-54
02/02/2001, 11:03
49
Содержание Lifebook i-4190
Страница 13: ...SECTION SECTION 1 SECTION 1 1 ...
Страница 46: ...SECTION SECTION 2 SECTION 2 2 ...
Страница 65: ...SECTION 3 SECTION SECTION 3 3 ...
