Fujitsu LifeBook E7010, Руководство пользователя

Страница: 73 / 134

67
T r o u b l e s h o o t i n g
Shutdown and Startup Problems
The Power and Suspend/
Resume button does not
work. The Power and Suspend/
Resume button is disabled
from the Power -> Advanced
submenu of the setup utility. Enable the button from the setup utility.
You did not hold the button
in long enough. Hold the button longer. This may need to be a few
seconds if your application is preventing the CPU
from checking for button pushes.
There may be a conflict with
the application software. Close all applications and try the button again.
The system powers up, and
displays power on informa-
tion, but fails to load the
operating system. The boot sequence settings
of the setup utility are not
compatible with your
configuration. Set the operating source by pressing the [ESC] key
while the Fujitsu logo is on screen or use the [F2]
key and enter the setup utility and adjust the source
settings from the Boot menu.
(See BIOS Setup
Utility on page 35 for more information)
You have a secured system
requiring a password to load
your operating system. Make sure you have the right password. Enter the
setup utility and verify the Security settings and
modify them accordingly.
(See BIOS Setup Utility on
page 35 for more information)
Internal hard drive was
not detected. Use the BIOS setup utility or Primary Master
submenu, located within the Main menu, to try to
auto detect the internal hard drive.
Your system display won’t
turn on when the system is
turned on or when the
system has resumed. The system may be password-
protected. Check the status indicator panel to verify that the
Security icon is blinking. If it is blinking, enter your
password.
An error message is
displayed on the screen
during the notebook
(boot) sequence. Power On Self Test (POST) has
detected a problem. See the POST messages to determine the meaning
and severity of the problem. Not all messages are
errors; some are status indicators.
(See Power On Self
Test Messages on page 70 for more information)
Your LifeBook notebook
appears to change setup
parameters when you start
it. BIOS setup changes were not
saved when you exited the
BIOS setup utility, returning it
to previous settings. Make sure you select Save Changes And Exit when
exiting the BIOS setup utility.
The BIOS CMOS hold-up
battery has failed. Contact your support representative for repairs.
This is not a user serviceable part but has a normal
life of 3 to 5 years.
Video Problems
The built-in display is
blank when you turn on
your LifeBook notebook. Something is pushing on the
Closed Cover switch. Clear the Closed Cover switch. (See Figure 2-4 on
page 8 for location)
The angle of the display
and the brightness settings
are not adequate for your
lighting conditions. Move the display and the brightness control until
you have adequate visibility.
Problem Possible Cause Possible Solutions
B5FH-4491-01EN-00.book Page 67 Friday, April 19, 2002 11:24 AM