Fujitsu Lifebook E6550, Инструкция по эксплуатации

Страница: 39 / 110

SECTION 1
31
Loading/Ejecting an LS-120 disk
The following explains how to load/eject an LS-120 disk in/from the LS-120 disk drive.
* Available on certain models.
Loading an LS-120 disk
Insert an LS-120 disk into the LS-120
disk drive.
Insert an LS-120 disk into the LS-120 disk
drive with its label side up and the shutter
facing inwards.
EJECT
button
Ejecting an LS-120 disk
Press the EJECT button.
While confirming that the mark of the
status indicator LCD is going out, press the
EJECT button.
EJECT
button
Critical Point
Since the LS-120 disk drive of this personal
computer locks the disk electronically, any
LS-120 disk can be ejected only when the
personal computer is in the operating mode.
If the LS-120 disk is not ejected for some
reason, insert the tip of a paper clip or the
like into the EJECT jib hole. The disk will be
ejected.
If the LS-120 disk is ejected while the
mark of the status indicator LCD is on, the
data stored in the disk may be damage.
To protect data stored in an LS-120 disk from erasure or to prevent additional data writing on
a disk, slide the write protector knob of disk to make the square hole open (write inhibit
status). To make the disk enabled for overwriting or additional writing, slide the write protector
knob again to shut the square hole (write enabled status).
Bis Sec 1(22-33) 2/2/00, 11:26 31