Fujitsu IP-900 II D, Руководство пользователя по оборудованию

Страница: 69 / 104

Chapter 5 Troubleshooting
IP-900E/IP-900D series
55
5.1
Help Information
If a problem is found in device operation, take recommended action described in the table below,
according to the applicable conditions. If the action does not solve the problem, contact a service
representative.
Possibility of electric shock
Contact your system administrator before checking the voltage of a power
outlet. Otherwise, electric shock may occur.
Table 5.1.1 Problem descriptions and recommended actions(IP-900E)
No. Class Status Description Recommended action
1. Is the power cable connected?
Make sure that the power cable is properly
connected to the outlet.
2.
Power
Power cannot
be turned on.
Is the outlet voltage normal?
Measure the voltage with a tester to confirm
that the voltage is normal.
If another device is connected to the same
outlet, check the operation of the device.
3.
The ALM LED
is blinking.
Check the log information from the
browser.
The temperature inside the device
has risen to the critical level, the
fan speed has fallen, or a CF card
access error has occurred.
If the ambient temperature of the device is
too high, make proper arrangements to
lower the ambient temperature. If there is
any shielding material in the installation
space, remove it.
If the fan speed is low, the fan needs to be
replaced. Contact a Fujitsu Service Center.
In the case of a CF card access error, restart
the device. If the problem persists, contact
a Fujitsu Service Center. The CF card or
the device needs to be replaced.
4.
The ALM LED
is on.
The device is faulty.
Troubleshoot from the control terminal.
(For details, see the software manuals.)
Is the ambient temperature of the
device higher than that in the
specifications?
Adjust the temperature so that the ambient
temperature of the device meets the
specification's condition.
5.
Device
The LEDs
excluding LAN
are on.
Is there any shielding material in
the installation space?
Remove the shielding material.
6.
Is the port setting correct? Check the data input-output port setting.
7.
Is the data input/output device
operating normally?
Check the operation of the data input/
output device.
8.
Data
Data
communication
is disabled.
Are the device and the
communication destination device
correctly connected?
Check cable connections between the device
and communication destination device and
the cable pin assignments.
9.
Is the power to the video/audio
output device (such as a camera)
selected for input turned on?
Verify the power supply and operation of
the video/audio output device selected for
input.
10.
The INDWN
lamp lights in
orange.
Is this device correctly connected
to the video/audio output device?
Check the cable connection between this
device and video/audio output device.
11.
Vi
de
o
The INDWN
lamp blinks in
orange.
The synchronization slipping
occurs for encoder or the reference
clock input fault occurs for
decoder.
Make sure that the video input signal for
encoder or the reference clock input signal
for decoder is set correctly.
5.1