6
PREPARATION
CAUTION
M
Take care to prevent infants from acciden-
tally swallowing batteries.
M
When not using the remote controller for an
extended period, remove the batteries to
avoid possible leakage and damage to the
unit.
M
If leaking battery fluid comes in contact
with your skin, eyes, or mouth, imme-
diately wash with copious amounts of
water, and consult your physician.
M
Dead batteries should be removed imme-
diately and disposed of properly, either in a
battery collection receptacle or to the appro-
priate authority.
M
Do not attem pt to recharge dry batteries.
Never mix new and used batteries, or bat-
teries of different types.
Batteries should last about 1 year under
normal use. If the operating range of the
remote controller becomes appreciably
reduced, replace the batteries and press
the RESET button with the tip of a ball-
point pen or other small object.
Turn on the Power
1
Turn on the circuit breaker.
Load Batteries (AAA/R03/LR03
×
2)
1
Press and slide the battery compartment lid on the re-
verse side to open it.
Slide in the direction of the arrow while pressing the
mark.
2
Insert
batteries.
Be sure to align the battery polarities (
) correctly.
3
Close the battery compartment lid.
Set the Current Time
1
Press the CLOCK ADJUST button.
Use the tip of a ball-point pen or other small object to press the button.
2
Use the TIMER SET (
/
) buttons to adjust the
clock to the current time.
button:
Press to advance the time.
button:
Press to reverse the time.
(Each time the buttons are pressed, the time will be advanced/reversed in
1-minute increments; hold the buttons depressed to change the time quickly
in 10-minute increments.)
3
Press the CLOCK ADJUST button again.
This completes the time setting and starts the clock.
To Use the Remote Controller
M
The remote controller must be pointed at signal receiver to operate correctly.
M
Operating range: About 7 meters.
M
When a signal is properly received by the air conditioner, a beeping sound will be
heard.
M
If no beep is heard, press the button of the remote controller again.
Remote Controller Holder
3
To remove the remote controller.
(when use at hand).
1
Mount the holder.
2
Set the remote controller.
Screws
Insert
Press in
Slide up
Pull out
