3.2
Appliance start up.
•
The installation and 1st start up of the appliance
must be done by a qualified installer. That person
will also give you instructions on starting and
running the appliance.
•
Ensure that the installation is fully filled with water
and has been correctly bled and that there is a
s uffic ient pres s ure of 1.5 to 2 bars on the
manometer (Ref. 2, fig. 4).
•
Close the installation’s main circuit breaker.
In winter, so that the compressor can be preheated,
close the installation’s main circuit breaker (outside
unit’s power supply) some hours before pressing the
on/off button.
3.3
Quick start-up
Once your installer has started your installation for
the first time:
•
Engage the heat pump’s ON/OFF button.
During the regulator initialisation phase, the display
shows all the symbols and then “Data, update” and
then “State heat pump”.
•
Select the “AUTO” heating mode (Fig. 5).
•
Select the DHW mode (Fig. 5)
if the installation is fitted with a DHW tank with
electrical back-up heating.
•
Set the current date and time (Fig. 6).
8
Instruction manual “1353-EN”
Heat pump, split, single service
Figure 3 - Opening the door
1
2
3
Xxxxxxx
xxxxxxx
xxxxxxx
xxxxx
Xxxxxxx
xxxxxxx
xxxxxxx
xxxxx
Xxxxxxx
xxxxxxx
xxxxxxx
xxxxx
Figure 4 - Start-up
1 - User interface
2 - Manometer (installation
hydraulic pressure)
3 - Start/stop switch
Figure 5 - Selecting the heating mode (AUTO)
and selecting the DHW operating mode
(domestic hot water)
Figure 6 - Setting the time and the date
Press the key OK
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Time of day and date
Operator section
Choose menu
Time and date
Press the key OK
Time of day and date
Hours / minutes
Select ligne:
Hours / minutes
or Day / Month
or Year
Press the key OK
Time of day and date
Hours / minutes
Make all
the settings
Press OK
to confirm
each setting
Press a regime key
to return to the
standard display
