- 19 -
Hardware Installation Process
English
8) F_PANEL (2x10 pins connector)
Ø
Please connect the power LED, PC speaker, reset switch and power switch etc. of your
chassis front panel to the F_PANEL connector according to the pin assignment above.
GN (Green Switch)
Open: Normal Operation
Close: Entering Green Mode
GD (Green LED)
Pin 1: LED anode(+)
Pin 2: LED cathode(-)
HD (IDE Hard Disk Active LED)
Pin 1: LED anode(+)
Pin 2: LED cathode(-)
SPK (Speaker Connector)
Pin 1: VCC(+)
Pin 2- Pin 3: NC
Pin 4: Data(-)
RST (Reset Switch)
Open: Normal Operation
Close: Reset Hardware System
PW (Soft Power Connector)
Open: Normal Operation
Close: Power On/Off
PD+ / PDG- / PDY- (Power LED)
Pin 1: LED anode(+)
Pin 2: LED cathode(-)
Pin 3: LED cathode(-)
1
2
17
18
1
1
1
1
1
HD+
PDY
-
PDG-
PD+
PW-
PW+
1
1
GD+
GN+
HD-
SPK-
NC
NC
SPK+
RST+
GD-
GN-
RST
-
9) RAM_LED
Ø
Do not remove memory modules while
DIMM LED is on. It might cause short or other
unexpected damages due to the 2.5V stand
by voltage. Remove memory modules only
when AC Power cord is disconnected.
+
_