4
Fig. 6 Remote Control Unit
H
SLEEP button
I
MASTER CONTROL button
J
SET TEMP./SET TIME buttons (
)
K
Signal Transmitter
L
TIMER button
M
FAN CONTROL button
N
START/STOP button
O
AIR FLOW DIRECTION
VERTICAL SET button
P
AIR FLOW DIRECTION
VERTICAL SWING button
Q
AIR FLOW DIRECTION
HORIZONTAL SET button
R
AIR FLOW DIRECTION
HORIZONTAL SWING button
Rear side (Fig. 7)
S
TIME ADJUST button
T
ACL button
(located inside battery compartment)
U
TEST RUN button
●
This button is used when installing the air
conditioner and should not be used under
normal conditions as it will cause the air
conditioner’s thermostat function to oper-
ate incorrectly.
●
If this button is pressed during normal op-
eration, the unit will switch to test opera-
tion mode, and the indoor unit’s OPERA-
TION indicator lamp and TIMER indicator
lamp will begin to flash simultaneously.
●
To stop the test operation mode, either
press the TEST RUN button once again, or
press the START/STOP button to stop the
air conditioner.
V
Remote Control Unit Display (Fig. 8)
W
Transmit Indicator
X
Clock Display
Y
Operating Mode Display
Z
T imer Mode Display
[
Fan Speed Display
\
Temperature Set Display
]
T imer Set Indicator
`
Temperature Set Indicator
Fig. 1 Indoor Unit
1
Operating Control Panel (Fig. 2)
2
MANUAL AUTO button
3
Indicator Panel (Fig. 3)
4
Remote Control Signal Receiver
5
OPERATION Indicator Lamp (red)
6
TIMER Indicator Lamp (green)
7
SWING Indicator Lamp (orange)
(VERTICAL SWING)
8
SWING Indicator Lamp (orange)
(HORIZONTAL SWING)
●
If the TIMER indicator lamp flashes when
the timer is operating, it indicates that a
fault has occurred with the timer setting
(See page 15 Auto Restart).
9
Intake Grille (Fig. 4)
;
UP/DOWN Air Direction Flaps
A
Moving Diffuser
B
RIGHT/LEFT Air Direction Louvers
(behind UP/DOWN Air Direction Flaps)
C
Drain Hose
D
Air Filter
Fig. 5 Outdoor Unit
E
Intake Port
F
Outlet Port
G
Pipe Unit
