Fujitsu AOBR09LGC, Руководство по эксплуатации

Страница: 6 / 20

En-5
PREPARATION
CAUTION!
● Take care to prevent infants from acciden-
tally swallowing batteries.
● When not using the Remote Control Unit for
an extended period, remove the batteries to
avoid possible leakage and damage to the
unit.
● If leaking battery fl uid comes in contact
with your skin, eyes, or mouth, immediately
wash with copious amounts of water, and
consult your physician.
● Dead batteries should be removed im-
mediately and disposed of properly, either
in a battery collection receptacle or to the
appropriate authority.
●
Do not attem pt to recharge dry batteries.
Never mix new and used batteries, or bat-
teries of different types.
Batteries should last about one year under
normal use. If the Remote Control Unit’s
operating range becomes appreciably
reduced, replace the batteries and press
the RESET button with the tip of a ballpoint
pen or other small object.
Turn on the Power
1
Connect the Power Supply Plug to an electrical outlet; in
the case of a direct line connection, turn on the circuit
breaker.
Load Batteries (Size AAA R03/LR03

2) *
1
Press and slide the battery compartment lid on the
reverse side to open it.
Slide in the direction of the arrow while pressing the mark.
* Batteries are not included with this product.
2
Insert batteries.
Be sure to align the battery polarities ( ) correctly.
3
Close the battery compartment lid.
Set the Current time
1
Press the CLOCK ADJUST button (Fig. 6
W
).
Use the tip of a ball-point pen or other small object to press the button.
2
Use the TIMER SET ( / ) buttons (Fig. 6
V
) to
adjust the clock to the current time.
button: Press to advance the time.
button: Press to reverse the time.
(Each time the buttons are pressed, the time will be advanced/reversed in one-
minute increments; hold the buttons depressed to change the time quickly in
ten-minute increments.)
3
Press the CLOCK ADJUST button (Fig. 6
W
) again.
This completes the time setting and starts the clock.
To Use the Remote Control Unit
● The Remote Control Unit must be pointed at signal receiver (Fig. 1
4
) to operate cor-
rectly.
● Operating Range: About 7 meters.
● When a signal is properly received by the indoor unit, a beeping sound will be heard.
● If no beep is heard, press the Remote Control Unit button again.
Remote Control Unit Holder
3
To remove the Remote Con-
trol Unit (when use at hand).
1
Mount the Holder.
2
Set the Remote Control
Unit.
Screws
Insert
Press in
Slide up
Pull out
9317433044-05_OM.indb 5 9317433044-05_OM.indb 5 6/13/2013 2:39:53 PM 6/13/2013 2:39:53 PM