Fujitsu AOBR09LGC, Руководство по эксплуатации

Страница: 13 / 20

En-12
MANUAL AUTO OPERATION
Use the MANUAL AUTO operation in the event the Remote Control Unit is lost or otherwise unavailable.
How To Use the Main Unit Controls
Press the MANUAL AUTO button (Fig. 2
2
) for three seconds
on the main unit control panel.
To stop operation, press the MANUAL AUTO button (Fig. 2
2
) for three seconds.
● When the air conditioner is operated by
the controls on the Main Unit, it will oper-
ate under the same mode as the AUTO
mode selected on the Remote Control
Unit (see page 6).
●
The fan speed selected will be “AUTO”
and the thermostat setting will be stand-
ard (24
°
C).
3. Replace the Intake Grille.
1
Pull the knobs all the way.
2
Hold the grille horizontal and set the left and right mounting
shafts into the bearings at the top of the panel.
Mounting
shaft
Bearing
Knob
1
2
3
1
2
3
3
Press the place where the arrow on the diagram indicates
and close the Intake Grille.
Cleaning the Air Filter
1. Open the Intake Grille, and remove the air fi lter.
Lift up the air fi lter’s handle, disconnect the two lower tabs,
and pull out.
Air fi lter handle
Air fi lter (Right & Left)
Hooks(two places)
2. Remove dust with a vacuum cleaner or by washing.
After washing, allow to dry thoroughly in a shaded place.
CLEANING AND CARE
●
Before cleaning the indoor unit, be sure to turn it off and disconnect the Power Supply Cord.
● Be sure the Intake Grille (Fig. 1
8
) is installed securely.
● When removing or replacing the air fi lters, be sure not to touch the heat exchanger, as personal injury may result.
CAUTION!
Cleaning the Intake Grille
1. Remove the Intake Grille.
1
Place your fi ngers at both lower ends of the grille panel,
and lift forward; if the grille seems to catch partway through
its movement, continue lifting upward to remove.
2
Pull past the intermediate catch and open the Intake Grille
wide so that it become horizontal.
Intake Grille
Mounting
shaft
Knob
2. Clean with water.
Remove dust with a vacuum cleaner; wipe the indoor unit
with warm water, then dry with a clean, soft cloth.
● To avoid excessive wear of the part and components or malfunctioning of the air conditioning, the user/consumer shall perform
preventive maintenance through an accredited technical assistance, periodically. To know the preventive maintenance periodicity,
the consumer shall check with the accredited installer or an accredited technical assistance.
●
When used for extended periods, the indoor unit may accumulate dust inside, reducing its performance. We recommend that the indoor
unit be inspected regularly, in addition to your own cleaning and care. For more information, consult authorized service personnel.
● It is recommended for the user/consumer to demand a copy of the Work Order every time there is a visit of a technical assistance
for verifcation, maintenance, test or repair of the product.
●
When cleaning the indoor unit’s body, do not use water hotter than 40 °C, harsh abrasive cleansers, or volatile agents like benzene or thinner.
●
Do not expose the indoor unit’s body to liquid insecticides or hairsprays.
●
When shutting down the indoor unit for one month or more, fi rst allow the fan mode to operate continuously for about one-half
day to allow internal parts to dry thoroughly.
9317433044-05_OM.indb 12 9317433044-05_OM.indb 12 6/13/2013 2:39:55 PM 6/13/2013 2:39:55 PM