En-3
AIR CONDITIONER Wall Mounted Type
OPERATING MANUAL
CAUTION
• To prevent malfunction or damage of the remote controller:
-Place remote controller at where will not be exposed to
direct sunlight or excessive heat.
-Remove batteries if the product is not going to be used for
an extended period.
-Exhausted batteries must be removed immediately, and
be disposed according to the local laws and regulations of
your region.
• If leaking battery fluid comes in contact with your skin, eyes,
or mouth, immediately rinse with plenty of clean water, and
consult your physician.
• Obstacles such as a curtain or wall between the remote
controller and the indoor unit may affect the appropriate
signal transmission.
• Do not apply strong shocks to the remote controller.
• Do not pour water on the remote controller.
• Do not attempt to recharge dry batteries.
Battery (R03/LR03/AAA × 2) loading and remote controller preparation
1
4
2
3
5
7
6
5
Press CLOCK ADJUST button to start clock setting.
6
Set the time by pressing SELECT button.
Pressing ▲or ▼ changes the value by the minute.
Pressing down on ▲ or ▼ changes the value by 10 minutes.
7
Press the CLOCK ADJUST button again to complete the clock
setting.
Notes:
• Batteries are not included with this product.
• Use specified type of battery only.
• Do not use new battery and used battery together.
• Batteries can be used about 1 year in ordinary use.
• If the remote control range noticeably got shorten, replace the
batteries, and press RESET button.
You can quickly start operation with the following 3 steps:
Remote Controller Overview and Operations
1 START/STOP button
2 MODE button
Switches operation mode in following order.
AUTO
COOL
DRY
FAN
HEAT
Notes in HEAT mode:
• At the beginning of the operation, the indoor unit operates at very
low fan speed for about 3–5 minutes for preparation, and then
switches to the selected fan speed.
• Automatic defrosting operation overrides the heating operation when
necessary.
Note in COOL mode:
Indoor unit fan may stop from time to time to perform indoor-unit-
fan control for energy saving that enables power-saving operation by
stopping the rotation of the indoor unit fan when the outdoor unit is
stopped.
(continued)
In initial setting, this function is activated.
To inactivate the function, consult the installer or authorized service
personnel.
Even if the setting is changed, if the fan speed is set to “AUTO” in
COOL or DRY mode, this function still works to suppress the diffusion
of circulated indoor humidity.
3 TEMP. (temperature) buttons
Sets the desired temperature.
In COOL or DRY mode, the temperature needs to be set lower than
the current room temperature. In HEAT mode, the temperature needs
to be set higher than the current room temperature.
Otherwise, corresponding operation mode may not start.
Temperature setting range
AUTO/COOL/DRY
18–30 °C
HEAT
16–30 °C
Note:
Temperature control is not available in FAN mode.
18
15
16
14
19
2
9
10
13
8
11
12
17
20
3
1
5
6
4
7
9333003030-02_OM_EN.indd 3
10/6/2014 11:01:44 AM
