Chapter 2 Installation Procedures
Installing the Internal LTO-4 Half-Height Tape Drive
LTO-4 Half-Height Tape Drive User’s Guide
11
3
If you are installing the internal LTO-4 Half-Height Tape Drive in a
tape library system, connect the RS-422 serial interface cable to the
serial library port on the back of the drive. (The serial library port is
not used in workstation or server systems.)
4
Connect the internal drive DC power cable to the DC power
connector on the back of the drive.
5
Reinstall the system cover.
6
Reconnect the system AC power cord to the facility AC power
receptacle.
After connecting the interface and DC power cables, proceed to
Restarting the Internal Tape Drive System
in the following subsection.
Restarting the Internal
Tape Drive System
2
After connecting the internal drive interface and DC power cables:
1
Restart the workstation or server system.
2
Refer to the operating procedures in
chapter 3
to verify that the
internal LTO-4 Half-Height Tape Drive comes on and completes the
Power On Self Test (POST) functions.
As required, proceed to
IInstalling the LTO Driver Software
on page 12.
