8
9
2, Owner’s Manual
c
FPT-608106-FP-01
The owner’s manual
Getting Ready
Getting Ready
Printing
Printing
Advanced Printing
Advanced Printing
Error
Error
en:
The owner’s manual in English and French is available at “http://home.fujifilm.
com/products/dmp.”
fr:
Le manuel d’utilisation en Anglais et en Français est disponible sur le site
“http://home.fujifilm.com/products/dmp.”
1, Lithium Batteries
(CR2)
3, Mobile Printer
MP-300
Introduction
Contents of package
(P.18)
About IrSimple™
■
What is IrSimple™?
IrSimple™ is a high-speed infrared communication protocol that
permits high-speed data transfer. It was adopted in August 2005 as an
international standard by the IrDA
®
(Infrared Data Association
®
), which
is the standardization body for infrared technology.
IrSimple uses the same physical interfaces (SIR/FIR) as the existing
IrDA standard and has the following 2 communication modes:
z
Unidirectional
In this mode, data is only sent in one direction: from the sending device (primary
node). Problems that arise during communication cannot be corrected.
z
Bidirectional
This is a bidirectional mode in which the receiving device (secondary node)
responds to data sent from the sending device (primary node) by sending
the outcome of the data reception or requesting a resend, etc. This allows
problems that arise during communication to be corrected.
■
What is IrSimpleShot™ (IrSS™)?
This is a generic name given to unidirectional IrSimple™ communication.
■
IrSimple™ compatibility on the MP-300
The MP-300 supports both IrSimpleShot communication mode and
bidirectional communication mode.
■
Restrictions on IrSimple™ on the MP-300
z
The MP-300 can only operate as a receiving device (secondary node).
z
The MP-300 will only receive IrSimpleShot communication from a sending
device equipped with a high-speed infrared communication function (FIR).
(The MP-300 does not support IrSimpleShot communication using SIR.)
z
When a sending device equipped with a high-speed infrared
communication function (FIR) uses FIR to make an IrSimpleShot
transmission to the MP-300, the MP-300 can only receive data up to 1 MB
in size. (It cannot receive fi les larger than 1 MB.)
Note also that, depending on the transmission conditions (transmitted
packet size, etc.), the MP-300 may be unable to receive data from a
sending device even if it meets the above requirements.
■
IrSimple™ transmission speed
z
See “Guide to image sizes and transmission times” on P.27.
z
IrSimple™, IrSimpleShot™ and IrSS™ are trademarks of the Infrared Data
Association
®
.
z
“
” and Image Intelligence™ are trademarks of Fuji Photo Film Co., Ltd.
z
All other company, organization or product names used in this document are
trademarks or registered trademarks of their respective holders in Japan or other
countries. Note that the ™ and
®
symbols may be omitted in some instances in
this document.
c
The design of the cover page of Owner’s manual may differ depending on the regions.
