FujiFilm FUJINON XA22x7BES-D8, Руководство по эксплуатации

Страница: 39 / 76

EFP-58(B)_ E
- 11 -
1-⑤ Auto Cruising Zoom ON/OFF Switch
This switch changes the function of the auto cruising zoom to ON and OFF. The auto cruising zoom operation
can be performed using a zoom rate demand unit (Ex. ERD-10A-D05A). Refer to paragraph “ About Auto
Cruising Zoom Operation
”
on page 12.
1-⑥ Iris Comp ON/OFF Switch
This switch changes the iris compensation function to ON and OFF.
Note . In the iris remote mode (in this mode, iris is controlled manually from the camera side), the image of the
picture darkens when the extender is used. The iris compensation function prevent this happening.
1-⑦ Field Angle Comp ON/OFF Switch
This lens incorporates a function that compensates for the change of the field angle caused by focusing. This
function can be switched to ON and OFF with this switch.
1-⑧ Function Switch
Using this switch, the preset operation mode can be selected.
・ OFF: Zoom Preset Operation Mode
・ ON: Zoom and Focus Simultaneous Preset Operation Mode
2-① Camera Communication ON/OFF Swich
This switch changes the function of serial communication with a camera to ON and OFF.
Note. Set this switch to
“
OFF
”
when a malfunction occurs and it is assumed that the malfunction is caused by a
serial communication failure.
2-② Zoom Motor ON/OFF Switch
In normal operation, set this switch to ON.
2-③ Focus Motor ON/OFF Switch
In normal operation, set this switch to ON.
2-④ Iris Motor ON/OFF Switch
In normal operation, set this switch to ON.
•
Zoom Mode Select Switch
The characteristics of “ Zoom Speed vs Zoom Control Signal (from an analog zoom rate demand unit) ” can be
selected from ten modes. Refer to the following figure.
ZOOM CONTROL SIGNAL
最 大
0
No.0
No.4 (一般)
No.9
T W
ZOOM CONTROL SIGNAL
MAX
No.4 (Normal)
Z
O
O
M
S
P
E
E
D