FujiFilm FinePix A310 AS, Руководство по обслуживанию

Страница: 59 / 74

FinePix A310 Service Manual
5. Inspection
59
5
6
7
8
10
11
12
Movie recording
check
Movie playback
check
Card cover detect
check
Delete mode
check
Battery low check
Current
consumption
check
Factory setting
Movie
photography
LCD_ON
Playback
M mode
LCD_ON
Delete
Movie
Auto
photography
LCD_ON
Playback
(1) Select Movie mode.
(2) Half-press shutter button
-> full-press release.
(3) Five seconds later -> full-
press release.
(1) Select Playback mode.
(2) Press ‘+’ key to playback
movie.
(1) Open card cover to check
recording.
(2) Remove card.
(1) Select <Delete all frames>
from the menu, and press
the <OK> button.
(2) Press the <OK> button
again.
(1) Connect power cable jig
(2) Set voltage.
(3) Set mode dial to Replay
mode, and switch main
power ON.
(4) Set to pre-end voltage.
(5) Set to end voltage.
(1) Connect power cable jig.
(2) Set voltage.
(3) Set mode dial to Camera
mode, and switch main
power ON.
(4) Press the <DISP> button
to switch the LCD monitor
ON.
(5) After the through screen is
displayed, check current
consumption.
(1) Mode dial: Camera mode
(2) Return all settings to initial
values.
Flash: Auto
Monitor brightness: Center
Power saving: ON
USB setting: Card reader
Beep: LOW
Language: Engrish
Pixels: 1M normal
Photography mode: A mode
Date: Not set
(3) Inspection battery/
inspection xD-Picture card
not inserted in camera.
(4) Battery cover closed.
(5) LCD surface free of
contamination.
(6) Clean exterior of camera.
(1) Standby display on LCD.
(2) Movie recording begins.
Recording displayed on
LCD.
(3) Movie recording
completed. Recording on
card.
(2) Movie played back on
LCD monitor.
(1) Switch power OFF.
(1) [ERASE ALL OK? IT
MAY TAKE A WHILL]
displayed.
(2) Movie/photography
screen extinguished.
Refer to Battery Adjustment
for connection details.
(2) Set voltage to 3.0±0.3V.
(3) Starts normally.
(4) Set voltage to
2.10±0.02V. Battery
warning displayed.
(5) Set voltage to
1.95±0.02V. Lens
retracts and main power
switched OFF.
(2) Set voltage to 3.00±0.05V.
(5) Maximum current
consumption 500mA.
* Setting and clearing date
(1) Connect the USB cable
from the PC to the camera
(ensure that the PC is
switched ON).
(2) Open the card cover and
switch power ON
(POWER_ON) while
pressing the shutter
button.
(3) Switch power OFF
(POWER_OFF).
(4) Check that the date has
been cleared.
LCD monitor
Power supply
cable jig
Regurated
power supply
Ammeter
Sequence
Item Mode
Preparations for adjustment
(measurement points, subject, other)
Method of adjustment
(VRs, waveforms, required values)
Measuring
equipment
and jigs
Measurement points
(VRs, positions)