Fuji Xerox Document Centre C250, Руководство пользователя

Страница: 292 / 556

11 Setups
290
Setu
ps
11
Print Mode Settings
In [Print Mode Settings], you make settings relating to the printer feature.
When using CentreWare Internet Services, more detailed settings are possible. For more details, refer to
"CentreWare Internet Services" (P.212), and refer to the Network Administrator Guide.
The following are the places to reference for information about each setting.
Allocate Memory ......................................................................................................................290
Other Settings............................................................................................................................292
1
In the [System Settings] screen,
select [System Settings].
For the method of displaying the [System
Settings] screen, refer to "System Settings
Procedure" (P.240).
2
Select [Print Mode Settings].
3
Select the item to be set.
Allocate Memory
For each interface, set the memory capacity for the receiving buffer (temporary storage
for data sent from the client).
You can change the receiving buffer capacity depending on the pattern of use and
purpose. Increasing the receiving buffer capacity may allow a client to be released
sooner from an interface.
Important • If you change the memory capacity settings, the memory is reset, and therefore data stored
in all memory areas is lost.
• It is not possible to assign more than the total memory. When the power is turned on, if the
settings exceed the available memory capacity, they are automatically adjusted by the
system.
1
Select [Allocate Memory].
2
Select the item to be set or
changed, and select [Change
Settings].
Note • Select [ ] to display the
previous screen and select
[
] to display the next screen.
3
Set the setting value.