Fuji Xerox Document Centre C250, Руководство пользователя

Страница: 294 / 556

11 Setups
292
Setu
ps
11
Receiving Buffer - SMB Spool
„
Off
Do not use spooling. While SMB print processing is being carried out for one client,
data cannot be received over the same interface from another client.
Set a value for the dedicated SMB receiving buffer memory capacity from 64 to 1024
KB, in 32 KB increments.
„
Memory
Carry out spooling. The receiving buffer for spooling uses memory. When this
candidate value is selected, set the memory capacity of the receiving buffer for spooling
from 0.50 MB to 32.00 MB, in 0.25 MB increments.
Note that print data exceeding the set memory capacity is not accepted. In such cases,
select [Hard Disk], or [Off].
„
Hard Disk
Carry out spooling. The receiving buffer for spooling uses the hard disk.
Receiving Buffer - IPP Spool
„
Off
Do not use spooling. While IPP print processing is being carried out for one client, data
cannot be received over the same interface from another client. Set a value for the
dedicated IPP receiving buffer memory capacity from 64 to 1024 KB, in 32 KB
increments.
„
Hard Disk
Carry out spooling. The receiving buffer for spooling uses the hard disk.
Receiving Buffer - EtherTalk
Set the EtherTalk receiving buffer.
Set a value from 1024 to 2048 KB, in 32 KB increments.
Receiving Buffer - Port 9100
Set the Port9100 receiving buffer.
Set a value from 64 to 1024 KB, in 32 KB increments.
Other Settings
Make settings relating to the paper used in the printer.
1
Select [Other Settings].
2
Select the item to be set or
changed, and select [Change
Settings].
Note • Select [ ] to display the
previous screen and select
[
] to display the next screen.
3
Select the setting value.
4
Select [Save].