Fuji Xerox Document Centre C250, Руководство пользователя

Страница: 242 / 556

11 Setups
240
Setu
ps
11
System Settings Procedure
To make or change the system settings, it is necessary to be in System Administration
mode.
This section describes the basic procedure for system settings. The following are the
steps in the system settings procedure.
Step 1 Entering System Administration Mode .........................................................................240
Step 2 Entering the System Administrator UserID and Password............................................240
Step 3 Selecting the Operation Mode from the System Administrator Menu ..........................240
Step 4 Selecting an Item from the [System Settings] Screen....................................................241
Step 5 Setting the Feature .........................................................................................................242
Step 6 Exiting System Administration Mode ...........................................................................242
Step 1 Entering System Administration Mode
1
Press the <Log In/Out> button.
Step 2 Entering the System Administrator UserID and Password
To enter System Administration mode, enter the system administrator UserID. If you
are using the authentication feature, a password may be required.
It is recommended to change the system administrator UserID and password immediately after installing
the machine. For information about the setting, refer to "System Administrator Settings" (P.342).
1
Enter the system administrator
UserID with the numeric keypad,
and select [Confirm].
Note • The default UserID value is
"11111". When using the
Authentication feature, a
password is required. The
default password value is "x-
admin".
Step 3 Selecting the Operation Mode from the System Administrator Menu
1
Select [System Settings].
1 2 3
4 5 6
7 8 9
0 #
C
<Log In/Out>
button