Fuji Electric UG220H Series, Руководство пользователя

Страница: 104 / 275

2 - 35
MITSUBISHI PLC • 6
(A Link + Net 10)
12
POD can access other CPUs on the NET II(/B) or NET/10 when POD is connected to one of the link units
that the data link system or network system consists of.
Select “A Link + Net10” as PLC setting when configuring the screen data on the panel editor.
To access other CPU on the NET II (/B) or NET/10 from POD.
• In case of NET II(/B), only the network which has the CPU with the link unit connected to the POD (e.g.
No. 1) can be accessed.
(Available CPU No.: 0 to 30)
• In case of NET/10, other networks (No. 2, No. 3) can be accessed in addition to the network No. 1.
(Available CPU No.: 1 to 30)
To read/write the memories of the CPU(e.g. 1-1 of CPU) which has the link unit to be connected to the
POD :
Set the CPU No. to “31” on the
panel editor.
Response time will be equivalent to
the case of 1 : 1 communication.
Please note that response will be delayed
due to the transient transmission when
the CPU No. is set to other than “31”.
In this case, use [OUT_ENQ] command of the [SYS] to
program the macro. A CPU from a different network
cannot be accessed on the same screen.
When accessing PLCs of other network numbers on
NET/10, specify the network number to be connected
with the screens Open Macro in Panel Editor.
CPU
(1-1)
Link Unit
CPU
(1-5)
CPU
(1-4)
CPU
(1-3)
CPU
(1-2)
(2-2)
CPU
(2-5)
CPU
(2-1)
CPU
(2-4)
CPU
(3-5)
CPU
(3-4)
CPU
(3-3)
CPU
(3-2)
CPU
(2-3)
(3-1)
Network No. 1
Network No. 2
Network No. 3
POD
12 MITSUBISHI PLC
•
6