6
EN
EGT-4 CAN
4. Installation
Installation must be performed with the wiring and battery disconnected. It’s
very important that the wiring harness be as short as possible and to cut off
all excess wiring. Never roll up unused wiring. These measurements will avoid
problems with electromagnetic interference, common in every electronic
equipment.
The wiring harness must be protected from sharp edges that may damage
wires and cause short-circuits. Pay attention when passing the wiring harness
through holes, always using rubber shields or other kind of wire protection. In
the engine bay, route the wiring through places that aren’t exposed to excessive
heat and won’t get close to moving parts of the engine. Plastic covers are
recommended for the wiring harness.
4.1 Mounting
The EGT-4 must be mounted to a flat surface of the vehicle using the holes in
the side flaps. The EGT-4 has a safety lock for the thermocouple connectors,
to lock it, follow the steps described below.
a - Loosen the two side screws (1) of the EGT-4 lock (2) and pull it out
b - Insert the K-type thermocouple connector on EGT-4
c - Place thermocouple cable fitting in the lock
d - Push the lock until it touches the thermocouple connector and tighten
the two side screws
1
1
2
Содержание EGT-4 CAN
