FuelTech EGT-4 CAN, Руководство пользователя

Страница: 7 / 20

7
EN
EGT-4 CAN
4.2 Wiring Harness with PowerFT ECU’s
A - Black wire - Ground
B - Red wire - Switched 12V
1 - Male connector (rear view)
2 - Female connector (rear view)
3 - Terminator male connector (rear view)
4 - White/Black wire - CAN LOW - pin 3
5 - White/red wire - CAN HIGH - pin 4
6 - Any other FuelTech CAN device, like WB-O2 Nano or FTSPARK
NOTES
-
The use of the terminator (3) is mandatory for the CAN network
correct functioning.
-
When assembling the thermocouple, always use compensated
connectors. The yellow from the sensor is the positive terminal (+) (narrow
pin) and the red wire is the negative terminal (-) (wide pin).
IMPORTANT
If longer wires are needed in order to place the thermocouple,
always use compensated connectors (male and female) or pre-
made thermocouple extensions.
Use the same wire type if a longer wire for the sensor is needed.
The splice, the use of a compensate male and female connector
specific for type K thermocouple is mandatory.
4
3
1 3 4 5 7 2 6
10 12 13 8 9 11
14 16 17 15 18 19
20 22 25 26 21 23 24
1 3 4 5 7 2 6
10 12 13 8 9 11
14 16 17 15 18 19
20 22 25 26 21 23 24
2
1
4
3
1
2
3
5
B A
4
FTCAN 2.0
equipment
6
NOTE
Extension Harness sold separately.