Fuel RG 500, Руководство пользователя

Страница: 42 / 48

42
Engineering Mode
Press and hold RESET and ENTER keys for 2 seconds to enter Engineering Mode. The console will
beep for 1 second and the top display will flash. Press UP or DOWN to select setting section (Sound
→
Odo
→ Sound). If there is no activity for 30 seconds in engineering mode, the console will switch to
STANDBY mode. You may press RESET to exit engineering mode manually. If you remove the
batteries, the settings will reset to factory settings and Odo value will be 0.
C.
Sound ON/OFF
•
Choose Sound / Audio ON/OFF settings (SOUND sign flashes) and press ENTER.
•
The console will
display “ON” or ”OFF” – choose the setting you want.
•
Press ENTER to confirm the setting (on or off). The console will return to Engineering Mode.
D.
ODO
•
Choose ODO settings (ODO sign will show up).
•
When exercise time is over 1:59:59, the LCD will
display “H” sign.
•
Press UP or Down to switch to other Engineering mode settings.
Using a chest belt
You may use a (compatible) chest belt with this device. Pay attention to the instructions of the chest belt
– however,
generally a connection between a chest belt and your device may be established like this:
1. Attach the transmitter to the elastic strap using the lock button.
2. Adjust the strap as tightly as possible as long as the strap is not too tight to remain
comfortable.
3. Position the transmitter with the logo centered in the middle of your torso facing
away from your chest (some people must position the transmitter slightly left of
center). Attach the final end of the elastic strap by inserting the round end and,
using the locking parts, secure the transmitter and strap around your chest.
4. Position the transmitter directly below the pectoral muscles.
5. Sweat is the best conductor to measure very minute heart beat electrical signals.
6. However, plain water can also be used to pre-wet the electrodes (2 ribbed oval areas on the reverse side of
the belt and both sides of the transmitter). It
’s also recommended that you wear the transmitter strap a few
minutes before your work out. Some users, because of body chemistry, have a more difficult time in achieving
a strong, steady signal at the beginning. After
“warming up”, this problem lessens.
7. Your workout must be within range - distance between transmitter/receiver
– to achieve a strong steady signal.
The length of range may vary somewhat but generally stay close enough to the console to maintain good,
strong, reliable readings. Wearing the transmitter directly on bare skin assures you of proper operation. If you
wish, you may wear the transmitter over a shirt. To do so, wet the areas of the shirt that the electrodes will rest
upon.
Note : The transmitter is automatically activated when it detects activity from the user
’s heart. Additionally, it
automatically deactivates when it does not receive any activity. Although the transmitter is water resistant,
moisture can have the effect of creating false signals, so you should take precautions to completely dry the
transmitter after use to prolong battery life (estimated transmitter battery life is 2500 hours). The replacement
battery needs to be of the type CR2032.