Fubag INMIG 200 Plus, Руководство оператора

Страница: 7 / 32

www.fubag.ru
O m perator's anual
- - 7
Connection between Welder and Power Source
High voltage danger from power source! Consult a qualified electrician for proper
installation of receptacle at the power source. This welder must be grounded while in use to
protect the operator from electrical shock. If you are not sure if your outlet is properly
grounded, have it checked by a qualified electrician. Do not cut off the grounding prong or
alter the plug in any way and do not use any adapters between the welder's power cord and
the power source receptacle. Make sure the POWER switch is OFF before connecting your
welder's power cord to a properly grounded 220VAC.
Connect the power source cable at the back board of the welder into the single phase 220 voltage
power network with breaker; 380 voltage power sources is strictly prohibited to the welder which will
severely damage the welder, otherwise the user should take the consequences for it.
The melting current of the fuse is 1.2~1.5 times of its rated current.
Notice:
1-
220
phaze
power supply
V
Input connection Sketch
Item
Circuit breaker, А
≥
Fuse (Rated current), А
40
Knife Switch, А
Power cord, мм
2
≥ ,
2 5
I 200 NMIG
TORCH SWITCH
WORK
PIECE
TORCH
GROUNDING
CABLE
POWER INPUT CABLE
GAS
FLOWMETER
СО
2
GAS PIPE
40
36