Fubag INMIG 200 Plus, Руководство оператора

Страница: 11 / 32

- - 11
To exit the setup mode press the welding voltage thereby confirming your selection
.
To speed up the drawing of the welding wire through the supply hose torch, press and hold, feed
rate control device . When this flow rate is the maximum possible. To exit the maximum wire feed
speed , release the feed regulator
For these
embodiments, the machine preset optimal performance of the welding process, and it is only
necessary to adjust the magnitude of the wire feed speed to achieve a desired weld
Rotate the inductance can be adjusted character transfer of deposited material in the weld pool
Select control of the welding torch button position . The options are 2-stroke mode, 4-stroke
mode SPOT
- During welding , please adjust the supply of welding wire in accordance with the desired speed of
welding.
- Press the torch switch, the wire feed will be carried out automatically.
The arc is started as soon as the wire touches the material to be welded. When welding operation
indicator lights .
knob 14 .
- Press the torch switch till the wire extends to the nozzle.
- When wire feeding, make the cable straight.
- When wire feeding, make sure the wire is located on the wire roller groove reliably and the feeding
speed should be smooth. If the wire feeding speed is not smooth, please adjust the tension of the
wire roller
-
12
12
- When using MIG wire, the V groove wire roller should be used.
b)
-
.
-
а
“-”
“+”
b)
“ ”
Welding
There are five options for wires: 0,6 mm, 0,8 mm, 0,9 mm, 1,0 mm and 1,2 mm.
- 15 .
19
and .
) Debugging before welding
- Change the polarity on the vertical board, it is, connect MIG torch lead to , the ground cable lead
to .
- Install the torch, gas and welding wire, and then turn on the power switch. The power indicator is on
and fan works.
- Press the torch switch till the wire extends to the nozzle.
- When wire feeding, make the cable straight.
- When wire feeding, make sure the wire is located on the wire roller groove reliably and the feeding
speed should be smooth. If the wire feeding speed is not smooth, please adjust the tension of the
wire roller.
- When using flux wire, the gear type groove wire roller should be used.
Welding
- When welding, please adjust the welding current and welding voltage matchable according to the
set-up.
- Aim at the welding line, press down the torch switch, the wire feeds automatically. The arc is started
once the wire is touched the work piece. When welding, the working indicator is on.
Flux welding steps
www.fubag.ru
O m perator's anual