FT Fitness Technology PULLUP & DIP, Руководство пользователя

Страница: 24 / 37

www.pullup-dip.com
46 47
www.pullup-dip.com
Assembly steps
4| INDOOR INSTALLATION
5.2| Brick wall
Knock the anchor shells into the wall. Distribute multifunctional mortar according to
manufacturer‘s data into the anchor shells. Brush away excessive mortar which runs out with a
culinary cloth wipe. As a result press the eight thread rods up to the end into the anchor shells.
Excessive mortar which runs out from the anchor shells can be removed with a culinary cloth.
Allow the multifunctional mortar to harden according to manufacturer‘s data. Afterwards fix the
indoor adapter with the eight holes over the threaded rods to the wall. Attach the washers and
tighten the eight nuts with the spanner firmly.
Tip
For the brick wall installation it can be helpful to place the indoor adapter on the threaded rods
before the multifunctional morter has dried. However, the side arm may not be plugged in already
as long as the morter is not dry and the nuts may not be tightened (if necessary only easily set).
Assembly steps
4| INDOOR INSTALLATION
1| Level the drilling template with the water level and fix it with tape to the wall. The distance to
the ceiling should be at least 45 cm. The desired height can be determined by yourself.
2| Pierce the eight holes in the middle with a pencil and mark the drilling holes. Now the drilling
template can be removed.
3| Now predrill all eight holes with the 5 mm drill. With a brick wall an additional predrilling with
10 mm is recommended.
4| Afterwards drill the eight drilling holes with the drill (brick wall: 16 mm; concrete wall: 10 mm)
on final diameter. The drilling depth should be according to manufacturer‘s data.
5| Use a vacuum cleaner or a blowout device to get the drilling dust out of the holes. This is very
important for the stability of the installation material later!
According to the wall implement the following steps:
5.1| Concrete wall
Adjust the indoor adapter on the eight drilling holes. Knock the eight anchor bolts through the
eight holes into the holes of the wall and tighten the nuts with the spanner.