Rack-Mount Installation
Compass S2 units are designed to be rack mounted and are supplied with front rack-mount hardware. Rear rack-
mount brackets are available as a kit and are recommended for use when units are mounted in transit cases. When
rack mounting the unit, remember that maximum ambient operating temperature for the unit is 40 degrees C. Leave
at least one inch of space on each side and at the front of the unit to make sure that the airflow through the fan and
vent holes is not restricted. When installing equipment into a rack, distribute the units evenly to prevent hazardous
conditions that may be created by uneven weight distribution. Connect the unit only to a properly rated supply circuit.
Reliable grounding (earthing) of rack-mounted equipment should be maintained.
Power Cord/Line Voltage Selection
Compass S2 is rated to operate with the following supplies:
Input Power:
85-264 VAC, 47-63 Hz
Power Consumption:
175 watts maximum
The Compass S2 performs line voltage selection automatically. No user controls are required for line voltage
selection.
When the Compass S2 is used with 230-volt supplies, a UL listed line cord rated for 250
volts at 15 amps must be used. This cord will be fitted with a tandem prong-type plug.
WARNING
Figure 5-2: Tandem Plug
AVERTISSEMENT!
La choix de la ligne de voltage se realize automatiquement par I’Compass S2
Transformateur Graphique On n’apas besoin du controller usager pour la choix de la ligne
de voltage.
VORSICHT
Das Compass S2-Gerät mu beim Anschlu an 240V ~ mit einer vom VDE auf 250V/10A geprüften
Netzleitung mit einem Schukostecker ausgestattet sein.
Compass
S
2
7
Содержание CN-2002
