Frymaster FilterQuick FQE30, Руководство по обслуживанию

Страница: 37 / 52

1-32
1.15 FilterQuick™ Controller Service Procedures
1.15.1 FilterQuick™ Controller Troubleshooting
Problem Probable Causes Corrective Action
No Display on
Controller.
A. Controller not turned on.
B. No power to the fryer.
C. Power switch turned off.
D. Loose fuse holder.
E. Controller has failed.
F. Damaged controller wiring harness.
G. Power supply component or interface
board has failed.
A. Press the ON/OFF switch to turn the
controller on.
B. This fryer may have two cords: a controller
power cord and a main power cord. If the
controller cord is not plugged in, the
controller will not activate. Verify
controller power cord is plugged in and that
circuit breaker is not tripped.
C. Some fryers have a rocker power switch
inside the cabinet below the controller.
Ensure the switch is turned on.
D. Ensure fuse holder is screwed in properly.
E. Swap the controller with a controller known
to be good. If controller functions, replace
the controller.
F. Swap with a harness known to be good. If
controller functions, replace the harness.
G. If any component in the power supply
system (including the transformer and
interface board) fail, power will not be
supplied to the controller and it will not
function.
Controller locks up. Controller error. Remove and restore power to the controller.
Controller display
shows
filter
busy
or
WAIT
FOR FILTER
.
A. Another filtration cycle is still in
process.
B. Controller error.
A. Wait until the previous filtration cycle ends
to start another filtration cycle or until the
MIB board has reset. This may take up to
one minute.
B. If filter busy is still displayed with no
activity, ensure the filter pan is empty and
remove and restore
ALL power to the fryer.
Controller display
shows
RECOVERY
FAULT.
Recovery time exceeded maximum time
limit for two or more cycles.
Silence the alarm by pressing the

button.
Check that fryer is heating properly. Maximum
recovery for electric is 1:40. If this error
continues to appear call your FAS.
Controller displays
CALL TECH
Typically shown during software update.
Also may be that parameter data has
been corrupted or lost.
Press the FILTER button to bypass and continue.
Controller displays
SERVICE
REQUIRED
followed
by the error
.
An error has occurred.
Press YES to silence alarm. The error is
displayed three times. See list of issues in
section 1.14.5. Fix issue. The controller
displays
SYSTEM ERROR FIXED?
YES/NO.
Press YES and follow prompts.
Pressing NO will allow the fryer to cook in
most cases, but error will be redisplayed every
15 minutes.
Controller displays
ERROR RM SDCRD
Defective SD Card Replace card with another card.
Controller display is in
wrong temperature
scale (Fahrenheit or
Celsius).
Incorrect display option programmed.
See section 1.15.2 on page 1-34 to change
temperature scale.