Frymaster FBCR18 Series, Руководство по установке и эксплуатации

Страница: 16 / 60

3-2
P
ROGRAMMING THE
FBCR18 S
ERIES
C
OMPUTER
1. Turn the computer on by pressing the Power switch.
2. Press the Program Mode switch. CodE appears in the left display. Press, in sequence,
product buttons 1, 6, 5, and 10. (Press switch again to exit the programming mode.)
NOTE 1: The programming mode is not available while the computer is rethermalizing; the
display will flash
BUSY
.
NOTE 2:
To toggle between Fahrenheit and Celsius temperature display, press the Program
Mode switch, then enter the code 1 6 5 8 by pressing the corresponding product buttons.
Next, press the Temperature Check/Program Lock switch to lock in the new display option.
3.
SP
-
is displayed in the left window and the setpoint in the right. Use the product buttons to
change the temperature up to 205°F (96°C). For example, pressing 1, 9, and 5 programs the
setpoint for 195
°
. When the correct setpoint is displayed, press the Program Mode switch.
4.
SELP
(Select Product) appears in the display and the LEDs in the product buttons blink. Press
any of the product buttons to select it for programming.
5.
PULL appears in the display. Press the product buttons to enter the desired heating time in
minutes and seconds. Press the Program Mode switch to lock it in.
6.
SELP
again appears in the display. To program the heating time for another product, press the
product button to be associated with it and repeat Step 5.
7. Press the Program Lock switch to exit the programming mode.
O
PERATING THE
FBCR18 S
ERIES
R
ETHERMALIZER
1. Press the Power switch. The AutoFill feature will activate if the water level is below the
upper water level sensor.
2. CYCL appears in the display and the unit enters a burner on/off cycle until the water in the
cookpot reaches 180°F (82°C). At that time, the display changes to - Lo- and the burners fire
continuously. When the water in the cookpot is within 3°F of setpoint, the display changes to
four dashes (
- - - -
), indicating that the unit is ready for use. NOTE: To view the water
temperature, press the Temperature Check button once. Press the button twice to display the
setpoint.
3. After the four dashes appear in the display, place the product basket in the cookpot and press
the corresponding product button. The display counts down the heating time. The display
changes to
PULL . The small LED in the product button blinks and an alarm sounds to alert you
to remove the product. Press the button to silence the alarm.
U
SING THE
FBCR18 C
HILL
F
EATURE