Frye FONIX 7000, Руководство оператора

Страница: 57 / 216

General Operation
49
2.4.7 Putting multiple screens on a page
When printing with an external printer, it is possible to save paper by putting
two screen prints on one piece of paper. This is done by printing the first screen
on one half of the paper and leaving the paper halfway through the external
printer until you choose to print the second screen. To do this:
1. Press [MENU] in the Opening screen to open the Setup menu.
2. Change Ext Prnt #Scrns/Page under General to 2. Make sure Printer is set to
External.
3. Press [EXIT] to return to the Opening screen.
4. Go to the screen you want to print on the first half of the page.
5. Press [PRINT] to print the screen onto the first half of the paper. The paper
will remain halfway through the external printer.
6. Go to the screen you want to print on the second half of the paper, or run
another test.
7. Press [PRINT] to print the second screen and feed the paper the rest of the
way through the printer.
Note: if you decide you don’t want to take a second screen shot, press
[FEED] to feed the second half of the paper through the external pritner
without printing.
2.5 Display & Data
This section describes the Curve Characteristics Box that is common to every
measurement screen, and the data display that shows the numerical data of the
response curves in the Coupler screen and the real-ear measurement screens.
2.5.1 Viewing the Curve Characteristics Box
Each measurement screen has a Curve Characteristics Box that tells you differ-
ent information about each measured curve. It has several different columns of
data: Curve Name, Curve Title (real-ear only), Source Type, Source Transducer,
Source Amplitude, RMS Out, Correction Factors (COR, coupler only), and NR
(Noise Reduction). Figure 2.5.1 shows an example.
Figure 2.5.1—Curve Characteristics Box