Frontier TR2058, Руководство оператора

Страница: 31 / 44

15. Never replace hex bolts with less than grade five bolts unless otherwise specified,
i.e. shear bolts
10
.
16. When the machine is not hooked to the tractor, the driveline must be stored in a safe
place.
17. Where replacement parts are necessary for periodic maintenance and servicing,
genuine replacement parts must be used to restore your equipment to original
specifications. The company will not claim responsibility for use of unapproved parts
and/or accessories and other damages as a result of their use.
18. Unauthorized modifications to the machine may impair the function and/or safety of
the machine and reduce its life. If equipment has been altered in any way from
original design, the manufacturer does not accept any liability for injury or warranty.
4.02 - Service
The following illustrations show lubrication points. The frequency of lubrication given is
based on normal operating conditions. Severe or unusual conditions may require more
frequent lubrication.
Use a good quality
SAE
multipurpose type grease for all locations shown. Be sure to
clean fittings thoroughly before using grease gun. Immediately replace broken or
missing fittings.
Use 90 wt. or 140 wt. gear oil in gearbox.
Hourly or whenever an obstacle is hit:
1. Check machine condition, particularly the blades.
2. Replace any damaged or worn blades.
3. Remove any wrapping (stalks, weeds, trash, etc.) from rotor, especially from around
bearing supports on the rotor ends.
M
AINTENANCE
31
FRONTIER
A
ERATOR
-O
VERSEEDER
O
PERATOR
’
S
M
ANUAL
10
Refer to Table 4 - Torque Specifications, page 29.
4
3
2
1
Fig. 15
1. access panel to chain
2. chain case
3. rotor support grease fitting
4. stand