Frontier TR2058, Руководство оператора

Страница: 23 / 44

CAUTION: Check the tractor PTO rpm to ensure it is set at 540 and turns
clockwise.
CAUTION: Be sure the tractor tire pressure is correct. It is important to strictly
follow the safety guidelines and instructions laid out in the tractor manual.
To attach the implement to the tractor do the following:
Back the tractor up to the aerator-overseeder in order to slip the tractor hitch arms over
the hitch pins bolted to the frame.
Turn off the tractor engine.
The lower hitch pins (see fig. 11) may be put in either of 2 positions (upper or lower)
depending on the tractor. Optional hitch blocks are available for use on tractors with non
standard three point hitches. Secure the two arms with the lynch pins. Tighten the
tractor arms side movement with either the sway chains or blocks to limit side swing to
2”-3”. Connect the top link, locking it in place with the top hitch pin. Adjust it so the
aerator-overseeder is as near parallel to the ground as possible. A 1° to 2° rearward tilt
is acceptable
(see fig. 12) .
Install the end of the driveline with the safety slip clutch to the machine and the opposite
end to the tractor PTO. Be sure each end is connected securely with either the locking
pin or bolt and nut. Connect the driveline chains to the tractor and to the machine to
prevent the protective shielding from rotating during operation. If it was necessary to
remove the PTO protection to do any of the above operations, do not forget to replace
it.
O
PERATION
23
FRONTIER
A
ERATOR
-O
VERSEEDER
O
PERATOR
’
S
M
ANUAL
1
2
3
4
6
5
Fig. 11
1. hopper
2. top hitch
3. seed cups
4. PTO shielding
5. lower hitch pins
6. rotor shaft