Frontier TD2427, Руководство оператора

Страница: 8 / 44

6
HITCHING
Attaching to the Tractor
Figure 1
Crank the jack up or down to align the tractor draw bar with the hitch.
The tedder hitch is bolted on and can be adjusted up or down to accommodate various drawbar
heights (Figure 1). Select a height that keeps the tedder chassis level when it is connected to
the tractor.
When attaching to the draw bar always use a draw bar pin with a safety clip to ensure that the
tedder doesn’t bounce off of the tractor. Attach the safety chain to the tractor drawbar.
After attaching the tedder, crank the jack down until all the weight rests on the tractor drawbar,
then remove the jack and place it in the transport position. (Figure 2)
Attach the PTO shaft to the tractor. Make sure the locking balls in the splined coupling are
operational and that the PTO shaft locks securely on the tractor output shaft. NOTE: Be sure to
push the PTO stand down against the tongue to avoid damage to the PTO shaft shielding.
The TD2427 is equipped with hydraulic cylinders to fold the machine for transport. The hoses
should be connected to a double acting valve at the rear of the tractor. The slotted holes on the
side of the tongue (Figure 1) are storage holes for the hoses
Connect the wiring plug from the tedder into the female plug end on the tractor. If your tractor
is not equipped with this plug you will need to have it installed by your dealer. Never travel on
public roads without proper lighting.
Figure 2