Frontier TD2427, Руководство оператора

Страница: 12 / 44

10
ADJUSTMENTS
Axle Adjustments
The angle of the axles can be adjusted to raise or
lower the whole machine. This will allow you to tilt
the tedder forward more and get a more aggres-
sive tedding action. The tedders are set at the fac-
tory to run in the less aggressive position (shown
at right). To adjust to the higher position you will
need to pick the tedder up off the ground using
a hoist or a lift. With the tedder in the transport
mode, remove the 1/2” bolt, pull the axle forward
to meet the second hole, and reinsert bolt. Repeat
for all axles.
The axles can also be set on an angle. This allows
you to ted the edge of a field and the tedder will
throw the hay in further away from the fence, field
edge, etc. The picture at right shows the adjust-
ment assembly in the center, or straight position.
Pull the small lever to the right to pull the position-
ing pin out of the adjustment bracket. Swing the
axle assembly in the desired direction and release
the lever to lock the positioning pin into the proper
hole. Repeat the process for all the axles. Exam-
ple: When driving along the left side of a fence or
field edge, you will want to swing your axles to the
right.
Figure 11
Figure 12